The 6" Wizard trim saw by Diamond Pacific comes with D.C. motor with Ground Fault Circuit Interrupter, (to protect against electrical shock), high intensity lamp, sample bottle of Water Aid, angle block, and safety goggles. The blade is not included so you can choose your own blade. You can cut a 12" square tile right down the middle, yet it's base is barely more than a foot square itself. You can carry it with one hand even when its loaded with coolant. It has a built-in carrying handle, and a unique coolant system that allows this "portable" convenience. The Wizard uses water as a coolant so there's no messy oil to contend with. (When the stainless steel table is removed four compartments will be revealed, each containing a sponge. Water is added to the sponges that control the supply of water to the saw blade. Excess water is held in the sponges, preventing spills and water sprays. These sponges MUST BE REMOVED AFTER EACH USE of the saw to prevent the blade from rusting. The high intensity lamp is easily positioned to light the work area and is built into the saw. (Replacement bulbs are available.) Blades are easily changed, as the removable blade guard comes off with a few turns of a knob. NOTE: blade shown in photo is not included. The Wizard is all metal, with pan and table of stainless steel. The housing and pan have an industrial powder coated finish for great looks and life. The high torque, permanent magnet D.C. motor has plenty of power for trimming any hardness of rock. The unique angle block included with the trim saw allows you to finish-trim the edges of your cabs at a ten degree angle, giving you a headstart towards grinding the bezel of your cab. (For blade: arbor size is 5/8", do not use a blade with a rim thickenss over .025 as it may not fit. Standard blade should be 6" x .018. IMPORTANT SAFETY NOTE: The Wizard is a trim saw and not designed for slabbing rock. Wear safety goggles when using saw. FOB Barstow, CA. Shipping weight 22 lbs.